Nissan Qashqai J11 Right-Hand Headlight 26010HV00B

Restore full road illumination and factory styling with the genuine 26010-HV00B headlamp assembly. Designed for the facelifted Nissan Qashqai J11, this right-hand (passenger-side on left-hand-drive vehicles) unit blends a clear polycarbonate lens, halogen projector optics and an integrated LED daytime-running light to deliver crisp, legal light output and modern signature styling.

Key Benefits

• OEM precision fit – moulded mounting tabs and a 4-pin connector align with factory brackets and wiring; no coding or modification required.

• Halogen + LED hybrid – H11/HB3 halogen projector for low/high beam plus built-in LED DRL for high daytime visibility.

• UV-coated lens – hard-coated polycarbonate resists yellowing, stone-chip haze and harsh weather.

• Weather-sealed housing – integrated breather valves and OE gasket prevent condensation inside the lamp.

• Road-legal beam pattern – engineered reflector geometry meets ECE and DOT glare limits for oncoming traffic.

• Two-year Nissan parts warranty – confidence backed by factory support.

Vehicle Compatibility

• Nissan Qashqai II (J11) facelift – production 01 / 2017 → 2020

  • Trims: Visia, Acenta, N-Connecta, Tekna, Tekna+

  • Engine variants: 1.2 DIG-T, 1.3 DIG-T, 1.5 dCi, 1.6 dCi, 1.6 DIG-T

  • Position: Right-hand (RHD marking “RH”) for left-hand-drive vehicles

Verify by matching the stamped part number 26010HV00B / 26010-HV00B on your original headlamp.

Technical Specifications

• Light source: Halogen H11 low beam, HB3 high beam (bulbs not included)

• Daytime running: White LED light-guide strip

• Adjusters: Manual and electric levelling motors integrated

• Connector: 4-pin OEM plug

• Lens material: UV-stable polycarbonate

• Housing: Black ABS with aluminium heat sinks

• Weight: ≈ 3.2 kg

• Warranty: 24 months against manufacturing defects

Installation Snapshot

1. Disconnect battery and remove front bumper fascia.

2. Unbolt upper, side and lower headlamp screws (Torx T30).

3. Unplug 4-pin harness; lift out the old lamp.

4. Seat new headlight, tighten fasteners to 8 Nm.

5. Reinstall bumper, reconnect battery and aim beams to factory spec (cut-off height 3.5 cm at 3 m).